How pH affects the rate at which amylase digests starch, using continuous sampling with iodine. A required practical with calculation and graph questions.
—
Best score
—
Last attempt
Best attempt progress
0
XP earned
Watch first
FreeScienceLessons · AQA BiologyRequired Practical 5: Effect of pH on amylase
Method & key facts
The method (continuous sampling)
1. Put a drop of iodine solution into each well of a spotting tile
2. Mix starch solution and a buffer of known pH in a test tube, then place it in a water bath at a set temperature (for example 35°C)
3. Add amylase solution and start the stopwatch
4. Every 30 seconds take a drop of the mixture and add it to a fresh drop of iodine on the tile
5. Stop when the iodine stays orange-brown: all the starch has been digested. Record the time
6. Repeat with buffers of different pH values and repeat each pH to calculate a mean
Variables — fill in the table
Type
What it is
Independent variable
Dependent variable
Control: temperature
Control: volumes and concentrations
Control: iodine
Calculating and graphing
Rate = 1000 ÷ time taken (s). Faster digestion means a smaller time, so a bigger rate
Plot rate (y-axis) against pH (x-axis). The graph is a curve with a peak
The peak is the optimum pH, about 7 for the amylase in saliva
Away from the optimum the rate falls: the enzyme is denatured
Why the rate falls away from the optimum
Extreme pH changes the shape of the enzyme's active site
The starch no longer fits the active site, so fewer reactions happen
The change is permanent: the enzyme is denatured
Different enzymes have different optimum pH, for example pepsin in the stomach works best at about pH 2
Exam questions — 4 questions · 11 marks
⚡ Required practical. Method, variables, results and evaluation questions like these appear in every paper. Write in full sentences. The AI marks against the mark points.
1 markWhy iodine is usedAQA 8461 required practical style
What is iodine solution used for in this practical?
In an investigation, the starch was fully digested after 70 s at pH 6, 40 s at pH 7 and 200 s at pH 5. Calculate the rate at pH 6 using rate = 1000 ÷ time. Give your answer to 2 significant figures, and state which of the three pH values has the highest rate. (3 marks)
Hint: Divide 1000 by the time in seconds. Then compare the three rates.
+30 XP
6 marksDescribe the investigationAQA 8461 required practical style
Describe how you would investigate the effect of pH on the time taken for amylase to digest starch. Include the measurements and the control variables. (6 marks)
Hint: Cover the set-up, the sampling every 30 seconds, how you decide the end point, the repeats and the controls.