1. Label test tubes for each temperature (for example 10, 20, 30, 40 and 50°C) and set up water baths
2. Put equal volumes of milk and sodium carbonate solution in each tube, then add a few drops of phenolphthalein (pink in alkali)
3. Put the tubes and a separate tube of lipase solution in each water bath until they reach the temperature
4. Add the lipase to the milk, start a stopwatch and record the time for the pink to disappear (the pH falls)
5. Repeat for each temperature, then calculate the rate = 1000 ÷ time
Key ideas — fill in the table
Question
Answer
What breaks the fat in the milk down?
Products of lipid breakdown
Why the pH falls
Colour change with phenolphthalein
What decays milk in real life
Results pattern
Low temperatures: slow decay (particles have less energy, fewer collisions)
Rate increases with temperature up to an optimum (around 35–40°C)
Above the optimum the rate falls: the enzyme is denatured
Variables and safety
Control the volume and concentration of milk, carbonate, indicator and lipase; use the same type of milk
Wear eye protection. Use a thermometer in the water bath and check the temperature
Take care with hot water
If real microorganisms are used, do not incubate above 30°C in school. Wash hands
Exam questions — 4 questions · 10 marks
⚡ Required practical. Method, variables, results and evaluation questions like these appear in every paper. Write in full sentences. The AI marks against the mark points.
In this practical the pink colour of the mixture disappears. What does this show?
A The pH has risen
B The pH has fallen as acid is produced
C The milk has frozen
D The water bath has cooled
1 markWhy the pH changesAQA 8461 required practical style
Why does the pH of the milk mixture fall when lipase is added?
A Lipase is an acid
B Lipase breaks down lipids into fatty acids, which are acidic
C Lipase breaks down starch into glucose
D Lipase makes the milk more alkaline
3 marksExplain the fall in rateAQA 8461 required practical style
The rate of decay was highest at 40°C and much lower at 60°C. Explain why the rate was lower at 60°C. (3 marks)
Hint: Use the words denatured and active site.
+30 XP
5 marksPlan the investigationAQA 8461 required practical style
Describe how you would investigate the effect of temperature on the time taken for the pH of milk to fall. State three variables you would control. (5 marks)
Hint: Cover the temperatures, how you measure pH change, repeats and the controls.