1. Set up a series circuit: cell (or power supply), ammeter, and the test wire fixed along a metre rule. Connect the voltmeter in parallel across the length of wire being tested
2. Use a crocodile clip to choose a length (start at 10 cm). Switch on, read the current and potential difference, then switch off
3. Calculate resistance: R = V ÷ I
4. Repeat for lengths up to 100 cm, then plot resistance against length
Key points — fill in the table
Question
Answer
Ammeter position
Voltmeter position
Why switch off between readings
Shape of the resistance-length graph
Equation for resistance
Part 2: series and parallel
Measure V and I for one resistor, then for two resistors in series, then two in parallel (same p.d.)
Series: the total resistance is the sum of the resistances (R = R₁ + R₂)
Parallel: the total resistance is less than the smallest individual resistance
Reason: in parallel the current has more than one path, so more current flows for the same p.d.
Errors and safety
Zero error on meters; connections with extra resistance
Use a low p.d. so the wire does not get hot
Check the circuit diagram before switching on and make sure the meters are the right way round
Exam questions — 4 questions · 9 marks
⚡ Required practical. Method, variables, results and evaluation questions like these appear in every paper. Write in full sentences. The AI marks against the mark points.
A wire has a potential difference of 3.0 V across it when the current is 0.25 A. Calculate the resistance of the wire. A second piece of the same wire is twice as long. State its resistance. (3 marks)
Hint: Use R = V ÷ I. Resistance is directly proportional to length for the same wire.
+30 XP
4 marksSeries and parallelAQA 8463 required practical style
Two identical 6.0 Ω resistors are connected first in series and then in parallel. State the total resistance in series, and explain why the total resistance in parallel is less than 6.0 Ω. (4 marks)
Hint: Series resistances add. For parallel think about the number of paths the current can take.