1. Wrap a beaker in the first insulating material (for example bubble wrap, newspaper or foam). Hold it on with an elastic band
2. Heat water in a kettle and pour the same volume (for example 100 cm³) into the beaker. Put a lid on
3. Measure the starting temperature with a thermometer, then record the temperature every minute for about 10 minutes
4. Calculate the temperature drop. The smaller the drop, the better the insulator
5. Repeat with each material (and with no insulation as a control)
Variables — fill in the table
Type
What it is
Independent variable
Dependent variable
Control: water
Control: beaker
Control: material
Control: surroundings
Ideas to learn
Materials with low thermal conductivity are good insulators
Trapped air is a poor conductor and cannot form convection currents when trapped in small pockets
Thicker insulation slows energy transfer more
The water cools fastest at the start, because the temperature difference to the room is biggest
Safety and reliability
Hot water can scald: wear eye protection, pour carefully and mop up spills
Repeat each material and calculate a mean
Use a data logger or a digital thermometer to reduce reading errors
Plot temperature against time (cooling curve) and compare the gradients
Exam questions — 4 questions · 9 marks
⚡ Required practical. Method, variables, results and evaluation questions like these appear in every paper. Write in full sentences. The AI marks against the mark points.
Water at 80°C was left to cool for 10 minutes in a beaker with no insulation (final 52°C), with bubble wrap (63°C), newspaper (59°C) and foam (68°C). Calculate the temperature drop for each, rank the materials from best to worst insulator, and suggest one way to make the results more reliable. (4 marks)
Hint: Drop = start minus end. The smallest drop is the best insulator.